Change Staples

With Finisher

Open the compartment that contains the staple tray by opening the door marked in the image.

Step_1_0.JPG Step_1_1.JPG

Pull the marked handle towards you, which will cause the staples tray to appear in the left hand side of the tray you just pulled out.

Step_1_2.JPG Step_1_3.JPG

The staples tray can now be removed by pushing the green piece on the tray upwards. After that, it is possible to pull out the tray.

Step_1_4.JPG Step_1_5.JPG

The new staple tray can now be inserted back by pushing it back into the slot. Then push the green piece back into its previous position which will lock the tray. Then push the larger tray containing the staples tray back in and close the door to the compartment. Check the printer screen to see if the staples have been changed successfully. If there is a warning, something went wrong, otherwise everything should be fine.

Step_1_5.JPG Step_1_4.JPG

Without Finisher

Pull to the left with the marked handle in order to open the compartment that contains the staple tray.

Step_1.JPG

Pull the green piece of the staple tray out of the slot, which will loosen the tray. After that, it is possible to pull out the tray.

Step_2.JPG Step_5.JPG

In order to remove the staples from the tray, push the two arrows inside and pull up. After that, you can insert the new staples by performing the same steps in reverse. If you have troubles opening the tray, it may be easier for you to push under the green plastic piece, which will have the same effect as pushing on the arrows.

Step_3.JPG Step_4.JPG

The new staple tray can now be inserted back by pushing it back into the slot. Then push the green piece back into its previous position which will lock the tray.

Step_5.JPG Step_2.JPG

Now the compartment can be closed again. Check the printer screen to see if the staples have been changed successfully. If there is a warning, something went wrong, otherwise everything should be fine.

Step_1.JPG

Page URL: https://isg.inf.ethz.ch/bin/view/Main/HelpPrintingKnownIssuesStaple
2019-08-22
© 2019 Eidgenössische Technische Hochschule Zürich